How to avoid defects in jewelry box customization manufacturers?

2140

Published by
Jimmy at
December 25, 2017

Jewelry box in the production process, there are many steps, each step of the control, are the key body making jewelry box, process control quality determines the quality of operation throughout the entire process, and the process steps are connected together, this is the jewelry box production of the most wonderful.

In the process, every process hidden quality risk, the risk is not the process design is not perfect, nor the equipment performance is not comprehensive, mostly caused by the uneven and lack of skill level of worker quality awareness, control process and not rigorous, often the quality of these vulnerabilities is the biggest the quality and stability of the jewelry box. It is particularly important to improve the quality awareness of managers and operators, which is the most effective way to effectively avoid defects. The most common defects or quality control points;

1.: the loose side in four after a paper box body side of the mouth, there are suspended adhesion is not tight, and grey board paper.

2.: wrinkle formation of irregular surface of paper pasting, length of break.

3. broken angle: paper after paper jewelry box body four, the white paper corner breakage phenomenon.

4. (show): grey dew accuracy due to knife version of the production is not precise enough, or a positioning operation when the offset caused by pasting paper fold after lamination at dislocation, resulting in a gray board.

5. blisters: the irregular, different size of the bulge on the surface of the box body.

6. glue stains: the surface of the retention of glue marks.

7. protruding (acne): a granular material remains in the lower layer of the bag, which supports the surface of the surface and destroys the smoothness of the surface of the box.

8. low angle: gray board half through die-cutting or grooving, four fold forming adjacent two edges of the level of inconsistency.

9. ripple: jewelry box body paper is completed, in order to make the edge adhesion tightly, but also need to use the scraper on the box body four side scraping treatment, because the force is not standardized, the entire side will appear uneven length, a strip or vesicles, like water ripple.

Latest posts